Chinese Professional Hardness Block - ASME Non-piping calibration block ASME Sec V T-434.2.1 – TMTeck
Chinese Professional Hardness Block - ASME Non-piping calibration block ASME Sec V T-434.2.1 – TMTeck Detail:
ASME Basic Calibration Block is used for establishment of primary reference responses for UT examination of welds. ASME Basic Calibration Block 1 contains three side-drilled holes at 38mm deep minimum at 2.5mm diameter. the hole locations through the thickness are 1/4, 1/2 and 3/4 T. it also contains 2 EDM notches measuring 2% T deep * 6.4mm max wide * 25 long min. In accordance with ASME Sec V T-434.2.1
All standard blocks can be customized per request!
Product detail pictures:

Related Product Guide:
The organization keeps on the procedure concept "scientific management, high quality and efficiency primacy, purchaser supreme for Chinese Professional Hardness Block - ASME Non-piping calibration block ASME Sec V T-434.2.1 – TMTeck , The product will supply to all over the world, such as: Adelaide, Iran, Australia, We always insist on the principle of "Quality and service are the life of the product". Till now, our products have been exported to more than 20 countries under our strict quality control and high level service.

This manufacturers not only respected our choice and requirements, but also gave us a lot of good suggestions, ultimately, we successfully completed the procurement tasks.

Write your message here and send it to us